Close your cadence and try to start cadence by right click mouse and Run Cadence 16.6 as Administrator (Run as Admin)ġ0. If after doing step #7, it still does not work. Include THS4521_Pspice_model.txt into your profile -> add to Design (there are three options add to Global, add to Design, add to Profile), I usuallyĨ. Add part/symbol into your schematic: THS4521_model (and not THS4521)ħ. Add the THS4521_pspice_model.olb (preferably from my attachment)Ħ. Right click on left panel on "Design Cache" and "Library" and click on clear cache or someting similarĥ. Delete all your model files, all five of themĤ. olb files (all three of them as I saw on your screen captured)ģ. Delete any your symbol of THS4521 from your schematicĢ. You should be able to copy paste your schematic into the attached project.ġ. Let me know if you still have some questionsĪttached is my project. Then instatiate the symbol "THS4521_Model" into your schematic. That can be attached into Library section of the. SUBCKT which is THS4521_Model -> Export to Capture Part Library -> Now you will the. OLB from "Model Editor"-> Open the file on #1 ->Ĭlick/high light the top level. The easiest way to avoid mistakes on step #3, is by creating. OLB creation make sure that your symbol is called THS4521_Model (and not THS4521) since this is Don't copy paste partial content of the file on #1, so just call the entire thingģ. Make sure you don't alter THS4521_pspice_model.txtĢ. This will enable you to run with no problem.ġ. If it is not attached, you can go to simulation profiles, then go to Configuration Files tab -> Library -> Browse the File (THS4521_pspice_model.txt) ->Īdd to Design. Whether THS4521_pspice_model.txt is attached or not. Usually you can go to Left Panel of Pspice, then go to Pspice Resources section -> Model Libraries and check I am not 100% sure how familiar you are with calling the model into Pspice/Allegro environment.Īssuming you are not a first time user into Pspice/Allegro environment and assuming you are familiar with. I just tried it on Pspice 16.6 and I didn't see any problem.
0 Comments
Now when you have decided module boundaries it's time to create repositories for each of the module. Create Repositories with Submodules Create Main Module Repo This gives nicer debugger experience for developer without any hustle to enable symbols and be able to "step into" the package source code. Decision has to be made around type locations - where each type should go and which project will be used where.Īctually for development purposes using ordinary project reference is much more preferred way to work with. It's important to understand where each module ends and where next begins as you be referencing each other through sort of NuGet package references. This is a blog post about the stuff I had to do. So decided to split whole code-base into git submodules and setup separate repositories for each of the sub-systems.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |